Walther PPS .40 opinions or recommendations for similar gun
I'm looking to purchase a slim pistol that can fit into a large pocket and I''d like to it be chambered in .40 s&w. I know that there are disadvantages to pocket carry and there are smaller guns than the PPS that might do better in a pocket, but I'm choosing to pocket carry because my uniform and job duties make IWB carry risky in the sense that it would be easy to expose the gun, I would go so far as to have a seamstress extend my right pocket by an inch or two to accommodate the longer gun and I'm certain that it will fit height wise (relative to the pistol) because I can fit my Glock 30 in the pocket of my pants, it's just to thick to not be obvious. I'm looking for a .40 s&w gun because in addition to my Glock 30 I also have a Glock 22 so it would be nice not to have to add an additional pistol caliber at this time.
Initially I was looking at the S&W M&P shield but with the mag drop problems (that sometimes show up hundred of rounds into the service of the gun) I don't feel I could trust it as a carry gun at this point. So the next option that I came across is the Walther PPS in .40 S&W. I've been searching google and this forum but I can't find any high round count testimonials on the reliability/ durability of the PPS in the .40, just ones regarding the 9mm which seem to be mostly positive.
So, my questions are; Do any of you have any experience with this gun, especially concerning long term durability and reliability? If not is there a similar (slim small) pistol that you would recommend over the PPS? And then secondly; is a pistol in this size range inherently less reliable when chambered in .40? For simplicity and cost of stockpiling ammo, I really want to stick with .40, but if that means I'll be sacrificing reliability/ durability, I'd just bite the bullet and go with a 9mm.
Thanks for taking the time to read this lengthy post, I appreciate any responses.
Sent from my PC36100 using Tapatalk 2