This is a discussion on Glock 19 Gen 4 Issue within the Defensive Carry Guns forums, part of the Defensive Carry Discussions category; I just purchased a new Glock 19. I took the gun down to check everything was ok, but as I was putting the slide back ...
I just purchased a new Glock 19. I took the gun down to check everything was ok, but as I was putting the slide back on to the frame as I was lining the frame guildes with the slide it did not match up correctly. It would guide the gun slightly to the right side of the gun, if I put a little pressure back to the left side it then slides up correctly.
Any one else seen this?
It is all normal. The trigger bar on the Gen 4's have a "bump" on them which causes the slide to angle to the right when reassembling.
Edit: See picture.