...came my way.
This one is a plain ol' 4" HB Model 10-6 that had its hammer spur removed somewhere along the line and was reblued in a matte finish.
The gun came with some Uncle Mike's rubber grips, but I put on a set of S&W service grips I've had for years and a grip adaptor. There is small print visible on the frame showing that this gun was originally sold by Davidsons.
Screw heads were clean and the bob-job on the hammer was nicely done. The gun's timing is just fine with the cylinder locking up with absolutely no play in 4 of the 6 chambers. Frame-to-yoke fit is very nice and tight and the DA pull is slick.
This one will be a shooter and assuming that it groups well and functions properly, might wind up a carry revolver.