This is a discussion on 1911 SA Micro...my lil pain within the Defensive Carry Guns forums, part of the Defensive Carry Discussions category; Good luck with that....
Good luck with that.
"The pistol, learn it well, carry it always ..." ~ Jeff Cooper
"Terrorists: They hated you yesterday, they hate you today, and they will hate you tomorrow.
End the cycle of hatred, donít give them a tomorrow."
Glad you have that back - and hope it will run perfect for you.
Well I take an armorer to be someone well versed in a gun's manual of arms and all its component parts. He will replace one for one any part and be able to fine tune aspects.would a armorer or a gunsmith had worked on it? and what is the difference?
The gunsmith tho is the guy who can probably do all that - plus - he can make parts if needed - machine dovetails for sights etc - he is top of the heap I'd say - which is not to do down a skilled armorer!!
Your gun could have been worked on primarily by an armorer but perhaps a bit of smithing done too.
Only my $/50
Chris - P95
NRA Certified Instructor & NRA Life Member.
"To own a gun and assume that you are armed
is like owning a piano and assuming that you are a musician!."
http://www.rkba-2a.com/ - a portal for 2A links, articles and some videos.