80% AR Lower
Anyone with experience in milling an 80% Lower?
How difficult of a project is this? Thanks in advance for any advice, information, and for your help.
(Mod's if this needs to be posted under how to or somewhere else, thanks for the putting it in the right place)
It's fine right where it is.
If you have any machine work background its not too difficult. If you go to one of the build party's where they have a CNC mill set up you will need no experience at all. AR lowers are not that complex, and Ive seen some completed with a drill press and a dremmel! I wouldn't try the drill press and Dremmel method without a lot of experience. DR
Or you could just get a shovel and make a gun out of it.
This was psoted here once but I couldn't find it , DIY: Shovel AK - photo tsunami warning!!
Thanks. I don't have any background as a machinist. But like a challenge. It seems like a cool project. And Oneshot that is pure entertainment! I'm sure spades less than 16" will be included in any proposed AWB- they are so scary.