This is a discussion on Laser Engraving within the General Firearm Discussion forums, part of the Related Topics category; After Laser Engraving a gun do you need to coat the engraving so that it will not rust?...
October 18th, 2012 11:03 AM
After Laser Engraving a gun do you need to coat the engraving so that it will not rust?
October 18th, 2012 12:43 PM
If it's on a blued, firearm, I'd say normal gun care will do the job.
Retired USAF E-8. Lighten up and enjoy life because:
Paranoia strikes deep, into your heart it will creep. It starts when you're always afraid...
"For What It's Worth" Buffalo Springfield
October 18th, 2012 12:49 PM
You can just brush a very light coat of clear paste wax into it with a soft toothbrush. That should prevent any possible future rusting.
Liberty Over Tyranny Μολὼν λαβέ
October 18th, 2012 02:07 PM
Clear finger nail polish will do the trick
Our House Is Protected By The Good Lord And A gun. You Might Meet Both Of Them If You Show Up Inside My House Uninvited.
Search tags for this page
after laser engraving gun
best laser engraver for firearms
laser engraving paintball gun
laser etching paintball gun
rust around laser etching
Click on a term to search for related topics.
» DefensiveCarry Sponsors