This is a discussion on Taurus Judge 410 heat shield within the General Firearm Discussion forums, part of the Related Topics category; I put 10 rounds thru my new Judge Public Defender. While cleaning it, I noticed a small steel part fell off. I contacted Taurus and ...
I put 10 rounds thru my new Judge Public Defender.
While cleaning it, I noticed a small steel part fell off.
I contacted Taurus and they said it is a heat shield and do not fire the revolver without it in place.
The part is located in a small notch that is just above the spot where the cylinder meets the barrel.
They sent me a new part. I tried to install it. No success. I sent the gun back to Taurus requesting a replacement not a repair.
The part is not shown on the parts list.
Has anyone had the same issue.
I put 50-60 rounds through mine with no problems. I did notice that on the hammer and trigger, appears to be heat discoloring on the stainless steel. Is this normal?