Kel-Tec PF-9: Any Caveats?
This is a discussion on Kel-Tec PF-9: Any Caveats? within the General Firearm Discussion forums, part of the Related Topics category; Originally Posted by Adkjoe
For you guys that polished the feed ramp what kind of head did you use on the dremel to do it?
February 5th, 2010 01:14 PM
A dremel should never come NEAR a firearm (for the most part). Do your polishing by hand. You are POLISHING, not re-profiling the ramp! Some of the very early ones had a few probs, but I forget what they were. The forum should have a list somewhere of what serial numbers to look out for. I think mine started with a J6 which was outside of the bad range. Although I did have the hammer spring and takedown pin both break on me early (like 50-rds).
Originally Posted by Adkjoe
By Diddle in forum General Firearm Discussion
Last Post: October 21st, 2010, 12:16 AM
Search tags for this page
any cases of ad with a kel tec pf9
case kel tec pf9
fte kel tec pf9
kel tec pf9 fte
kel tec pf9 fte bulging case
kel tec pf9 pitted
kel tec pf9 rochester ny
kel-tec pf9 ftf
keltec pf9 fte with remington jhp
keltec pf9 pitting
mr softy pf9
slide pitting pf9
Click on a term to search for related topics.