Here's the same sequence on a long gun plain iron sights:
This is a discussion on Glow-On Gun Sights Paint: This is how you do it. within the Glow-On forums, part of the Site Sponsors category; Could you please post some method how to apply this paint over my sights? I just got mine, it looks very promising, i opened the ...
Could you please post some method how to apply this paint over my sights?
I just got mine, it looks very promising, i opened the envelope while I was on the driveway and when I got inside the house it was glowing already, I'm very impressed.
Robert T. Ca
Please read the instruction included, on the instructions sheet and under the labeling card.
-Important is to make sure you stir the paint very well some particles, are heavy and they go to the bottom of the vial.
-Use the wooden stick included, it's efficient.
-Basically grab a small drop set it over the spot and let it dry.
-Apply a clear coat layer over it to protect and make it easier to clean.
-it dries in minutes to the touch, but, (important) you let it cure for two days before you try to scratch it or holster your gun.
-after it dries, it basically becomes a synthetic cement.
-Top remove it, grab the back of a thin wooden brush and push hard to dislodge it. it can be softened with a drop of acetone, very carefully.
Here's a sequence on a pistol with very worn out sights.
I just received mine in the mail, excellent delivery time, followed the directions, and it works per advertised ...put
It on the front sight post of my AR15 .... Used a toothpick and applied three light coats, shaped it carefully, let each dry about 30-60 minutes ... I used it on three posts, they even stand out better in daylight, really stands out in dark conditions after you
Charge it .... Fine product ....