Just signed up. Looks like a great forum.
I'm off to do some reading!
This is a discussion on Hello from Kansas within the New Members Introduce Yourself forums, part of the DefensiveCarry.com Forum Office category; Hi gang! Just signed up. Looks like a great forum. I'm off to do some reading! Dirk...
"To disarm the people is the best and most effective way to enslave them."
"Gun control is a job-safety program for criminals."
John R. Lott
Dirk - greetings from PA
Chris - P95
NRA Certified Instructor & NRA Life Member.
"To own a gun and assume that you are armed
is like owning a piano and assuming that you are a musician!."
http://www.rkba-2a.com/ - a portal for 2A links, articles and some videos.
Welcome from Rocky Top Tennessee
One should never confuse good fortune with good training.
Illegitimus Non Carborundum.
In God we trust.
Hi PFF, welcome aboard.
What mods did you do to your XD?
Welcome from Montana.
When you’re wounded and left on Afghanistan’s plains,
And the women come out to cut up what remains,
Just roll to your rifle and blow out your brains,
And go to your God like a soldier.
USAF: Loving Our Obscene Amenities Since 1947
My current XD .45 service has been modded by Springer Precision with his carry trigger job, factory cleanup job, extended mag release and some TFO sights.
Of course, I had our Precision polishing treatment done (in sig below) on the barrel, feedramp and GR end. It is my carry favorite gun.
I just bought another XD .45 service that is getting the FULL treatment. Jess at On Target Custom Gun Works is doing his sweet grip job, which involves removing the front and rear grip checkering, recontouring the grip and then applying his nice stippling treatment. After it's stippled, he blasts the grip with a glass bead media to remove the rough edges. The result is a grip that offers very high traction without being rough. The modified grip is supposed to be a bit smaller and even more ergonomic than before.
Then, he's doing a "melt" treatment on my slide to smooth everything down and refinishing the slide afterwards. The frame is being recontoured also to allow a higher grip on the rear of the gun, etc.
He's also doing his carry trigger job with adj preset travel and installing a set of TFO sights, along with some smoothing of various internals. Gotta go with the extended mag release too, and I think he may be smoothing the slide release and take down levers.
When I get the gun back, I'll be doing our full polishing treatment and etching our logo's on the gun.
I don't think I've seen a single carry XD that is as trick as this one will be. I can't wait to get it done!
Welcome from Alabama.
Two things are infinite: the universe and human stupidity; and I'm not sure about the universe. Albert Einstein
Sounds great! Would love to see pictures when you get the second .45 Service back. Welcome by the way...
Semper Paratus (Always Ready)
Enjoy the site and welcome from West Tennessee!
Welcome from Washington.
The only thing that stops bad guys with guns is good guys with guns. SgtD