Lee micro charge bar?

[sjones]

Apicture is worth a 1000 words so can someone send me one of how you install the charge bar into the classic turret?I can't figgure out how it installs.Thanks. sj

[DefensiveCarry.com]

[Majorlk]

Apicture is worth a 1000 words so can someone send me one of how you install the charge bar into the classic turret?I can't figgure out how it installs.Thanks. sj

If you are talking about what I think you are, it goes in one of the Disk powder measures, replacing the fixed disk. It doesn't install in the press itself. The instructions come with the adjustable disk.

[sjones]

Thanks but I figgured it out after studying it for a while. sj

[Freedomofchoice]

I use the micro charge bar, and one thing I learned is if you use Lee Dies, each set comes with a sheet of reload data for each caliber you buy. In that reload data is a column which gives cubic centimeters. That figure corresponds directly to the setting on the micrometer for each type powder. Believe me this saves a HUGE amount of time in your set up when switching powders or calibers.

[sjones]

I just tried the disc's that came with the turret.Man,its a lot faster to use than the charge bar,assuming you have one with the grains you want to load so I just ordered the double disc kit. And also very consistant. sj

[Majorlk]

I have four Lee Disk measures, each one set up for a particular charge of a particular powder. Each is installed on a Dillon tool head. This way I do not have to bother adjusting the powder measures when changing calibers.

To get the correct amount of powder, I use the dick hole that gave me slightly under the desired charge, and then reamed the hole larger until the correct charge was dropped.

I do agree the adjustable charge bar is a nice addition to the measure.