So I've finally got my press mounted and put together, it is indexing fine but the case feeder mechanism keeps hanging or jumping the track pending on where in the cycle it feels like messing up.
The instructions that came with the press are garbage, I've seen the Lee videos and even some good stuff on YouTube, it looks to be installed correctly. Any ideas? I'll try and take some pictures later on, but right now I've got the case feeder off and will just load the cases manually.
I was fighting with this thing for about 2 hours today trying to get the indexing right which I did manage to do...GO ME! But the case feeder is still kicking my rear. I kept telling myself that "You should have bought a Dillon" throughout those 2 hours, but for $150 fully set up for .45ACP I couldn't beat it. Eventually I probably will get a Dillon 550 but this should do for now.
The instructions that came with the press are garbage, I've seen the Lee videos and even some good stuff on YouTube, it looks to be installed correctly. Any ideas? I'll try and take some pictures later on, but right now I've got the case feeder off and will just load the cases manually.
I was fighting with this thing for about 2 hours today trying to get the indexing right which I did manage to do...GO ME! But the case feeder is still kicking my rear. I kept telling myself that "You should have bought a Dillon" throughout those 2 hours, but for $150 fully set up for .45ACP I couldn't beat it. Eventually I probably will get a Dillon 550 but this should do for now.