|
|
|
|||||||
| Register | Forum Rules | FAQ | Members List | Calendar | Mark Forums Read |
| Forum Donations | DefensiveCarry Store | DefensiveCarry Gallery | USGO Gallery | Related Links | Forum Help & Extras |
| General Firearm Discussion The place for general firearms and shooting discussions that may not fit well in the forums focusing on concealed carry. |
 |
|
|
Thread Tools | Display Modes |
October 3rd, 2006, 10:25 PM
|
#1 |
|
Member
 
Join Date: Sep 2006
Location: Canton, GA
Posts: 93
 |
New Barrel Bushing
When I got my GI last month I was very happy and content with it.. after about 400 rounds I figured it was broken in enough but I still could not get consistent results at the range. sometimes to high sometimes to low. and quite a few fliers.
The barrel bushing was way to sloppy for my liking so I got a NM SS bushing and fitted it in. while I was at it I polished the barrel hood and the first 3" inches of the barrel end. The hood was getting some scuff marks that looked kinda bad to me. I used a fine bristle wire wheel to remove the parkerizing and then used Mothers Mag Polish and a buffing wheel to clean it up.. it is much more consistent now and I kinda like the way it looks to.. (similar to a Mil-Spec)     |
|
|
October 3rd, 2006, 10:31 PM
|
#2 |
|
VIP Member
 Join Date: Dec 2004
Location: Elsewhere
Posts: 17,476
|
Very nice a barrel bushing can do a lot fo some guns other the barrel needs to be fitted better
|
|
|
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
