|
|
|
|||||||
| Register | Forum Rules | FAQ | Members List | Calendar | Mark Forums Read |
| Forum Donations | DefensiveCarry Store | DefensiveCarry Gallery | USGO Gallery | Related Links | Forum Help & Extras |
| Reloading DefensiveCarry.com accepts no liability for reloading information posted by members. It is down to the individual posting to ensure safe standards and to readers to verify what they read - it is they finally who bear responsibility for useage of information. Remember - typos can occur! We strongly recommend that in most cases quoted loads be derived from recognized loading manuals and if possible these should be referenced. Where loads do not have back-up reference data available, for instance with use of an unusual powder, then posters are asked to please detail their method for establishing their data. Irresponsible publishing of unsubstantiated ''guestimated'' data is deprecated and may be heavily moderated. |
 |
|
|
Thread Tools | Display Modes |
June 29th, 2007, 12:18 AM
|
#21 |
|
Senior Member
 Join Date: Jun 2006
Location: tennessee
Posts: 507
 |
i will have to do some more research on the micro grooving but i read somewhere where it said should shoot cast bullets just fine. again will have to do some more research and i will see if i can put a link on it if i find something important.
ok after a little research there is a way to get cast bullets to work but as you mentioned you need to get the bullets "slightly" oversized to get more bit ont he bullet. as i said i was not 100% so i did my homework. C- =oP |
|
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
