Defensive Carry banner

1 - 9 of 9 Posts

·
Banned
Joined
·
1,774 Posts
Discussion Starter · #1 ·
I'm kinda new to semi auto's and my questions are; Is there much difference between +P and Nato rounds ? Also if a new gun needs x number of rounds to be broken in, would shooting higher pressure ammo hasten the process (assuming the gun can handle it) ?
 

·
Registered
Joined
·
36,326 Posts

·
Super Moderator
Joined
·
18,826 Posts
While +P might induce some small measure of additional stress to pistol components or even batter the gun over time, it really wouldn't contribute to a shorter break-in period. That's not to say that +P ammunition should be avoided in a quality gun. Use it for defensive purposes and shoot enough for familiarization.

I'd rather get to know the gun through shooting it with larger quantities of standard velocity ammunition, obtained for the same price as small boxes of premium +P ammunition.
 

·
Banned
Joined
·
1,774 Posts
Discussion Starter · #4 ·
Thanks for the replies guys. I accidentally bought 4 boxes of 124gr. Nato rounds and wondered if I could use it up safely. I did put one round in the mag of my heavier 9mm and never even notice a difference between it and the rest of the 115gr. FMJ rounds. This quote from a posted link:

"The short answer is that an occasional diet of 9mm NATO isn’t going to hurt your gun, provided it’s a well made modern gun. I certainly would not put 9mm NATO ammo into a Hi-Point, because I don’t want to eat the slide and I don’t trust a blowback operated gun with a zinc slide to stay together. But if you’re running a Springfield Armory 1911 in 9mm, or a well made pistol from a well made manufacturer you should be fine."

The gun I fired that Nato round from was a Hi Point C9 and it handled it very well. In fact I was reluctant to fire one in my Kel Tec PF9 because of the presumed increase in recoil. I do not get the attitude of some gun owners who say the Hi Point is a POS just because it didn't cost $500+, but that is for another thread.
Thanks again for the replies, I will treat the Nato rounds as +P's.
 

·
Banned
Joined
·
1,418 Posts
I'll save some people the reading time and tell you the simple answer: 9mm NATO spec is slightly higher pressure (about 4%) than standard 9x19mm or 9mm Luger. This is because the NATO technical manual dictates this, the thinking is that the ammo is usable in both sidearms and sub machine guns (MP5).

I personally love the Winchester NATO ammo, it has a nice little snap to it, not too much, just enough. Also, 124gr is my preferred weight in 9mm.
 

·
Registered
Joined
·
1,456 Posts
Don't know if this is accurate, but I have been told the primers are a bit harder with NATO loads.
 

·
Registered
Joined
·
18 Posts
Don't know if this is accurate, but I have been told the primers are a bit harder with NATO loads.
The Israeli 9mm being offered online right now is designed for submachine guns, and does have hard primers. Very unreliable in my buddies CZ.

The Winchester NATO runs great...
 

·
Premium Member
Joined
·
6,427 Posts
I'll save some people the reading time and tell you the simple answer: 9mm NATO spec is slightly higher pressure (about 4%) than standard 9x19mm or 9mm Luger...
...which puts it comfortably below 9mm +P pressure. It should be fine in any modern 9mm gun.
 
  • Like
Reactions: MJB_17
1 - 9 of 9 Posts
Top