Defensive Carry banner

1 - 13 of 13 Posts

·
Registered
Joined
·
1,536 Posts
Discussion Starter · #1 ·
I would like to design a proper holster for a pocket pistol, to allow concealment in a waiter's apron. I've seen the pocket stitched on the back of the square tie-around-the-waist apron, but would like to see more secure retention.

I am thinking of RetSUp's favorite FIST-INC pocket holster (with the thumb push-off thingy), with a piece of velcro added, to attach to a velcro piece inside a deep or double-compartment pocket I might sew into the apron. I would like to make two designs, one for a full-length apron and one for the square around-the-waist type.

Anyone want to add thoughts or suggestions on how best to do this? Thanks in advance.
 

·
Registered
Joined
·
632 Posts
20130619_200701.jpg

the holster, being made of kydex, smooth on the front side with the retention molding on the backside would be "hung" from your belt and covered with an apron of choice.

first thing to pop into my head.
 

·
Registered
Joined
·
531 Posts
Oddly enough, tonight as I carried a load of trash to the dumpster at 11pm I considered this as well. I'm a bartender and was all alone in a deserted parking lot. An apron holster would be ideal.
 

·
Registered
Joined
·
3,100 Posts
I think the double-pocket idea is your best bet and then allowing any pocket holster to go into it. Some folks may like the FIST option, others may prefer a Remora, and someone else may like the DeSantis they're already using.
 

·
Premium Member
Joined
·
116 Posts
I would think a tuckable appendix carry holster would be the easiest choice. Barring that just make sure whatever you do protects the trigger. Some stiff leather or Kydex would seem to be in order.
 

·
Registered
Joined
·
293 Posts
Wouldn't just a canted AIWB carry work? Just sew something a little more stiff, perhaps a square of leather or other material on the backside of the apron so when it's drawn taught it doesn't outline your firearm.
 

·
Registered
Joined
·
1,536 Posts
Discussion Starter · #10 ·
Yeah, I'm kinda thinking it might go that way... or a SmartCarry variant in appendix position, as she doesn't normally wear belts. The apron would provide a good 'cover garment' for possible printing (which would be minimal with a 380). This would also be a way she could wear the 'company' apron without modification. Thanks!
 

·
Registered
Joined
·
348 Posts
When I was a convenience store clerk and wore an apron, I carried a J frame snub nose revolver inside the pants with an open top belt clip holster made by Bianchi. It worked well except for times when I had to bend down to get something off the floor. If allowable, you can carry a small gun in a Sneaky Pete holster. It is fashionable and completely discreet. Third option could be a t-shirt holster worn under a button up shirt.
 

·
Registered
Joined
·
9,341 Posts
Yeah, I'm kinda thinking it might go that way... or a SmartCarry variant in appendix position, as she doesn't normally wear belts. The apron would provide a good 'cover garment' for possible printing (which would be minimal with a 380). This would also be a way she could wear the 'company' apron without modification. Thanks!

Check out 3Speed Holster Same concept but a much better thought out and quality made product.
 
1 - 13 of 13 Posts
Top