Defensive Carry banner
1 - 2 of 2 Posts

·
Registered
Joined
·
4,412 Posts
Don’t know about finding new sights but one way to tighten it would be to remove the sight then take a center punch and lightly stipple the area under the sight until you get a tight fit, just proceed slowly and test fit until it is tight enough.
That is what I was going to suggest also, had to do the same thing with the rear sight on my Colt Gov 380.
 

·
Registered
Joined
·
4,412 Posts
By the way when I stippled my Colt I stippled the sight not the gun.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top