Kel Tec P11: NEED HELP!

4757 Views 7 Replies 4 Participants Last post by cmidkiff, Jul 13, 2005

ExSoldier

Discussion Starter · Jul 12, 2005

Okay, I'm in north Florida for the next couple of days before heading home to Miami to finish off my summer vacation. My Father in Law has this Kel-Tec P11 that is filthy and bone dry. I need to field strip it and clean and lube it. CAN'T GET THE DURN THING APART! Any help in a clear cut set of instructions on a basic field strip would be greatly appreciated! I see the slide stop on the left side. I see that when the slide is locked to the rear, there is another notch on the left side just ahead of the slide stop notch. NOTHING that is in that area will move when the slide is to the rear! So I need some hints to leave the "Old Man" with a firearm in good working order and ready to go.

And NO I don't have a manual and I can't download a manual. This 83 year old guy is still on a dialup connection and using an ANCIENT computer.

Save

1 - 2 of 8 Posts

CLASS3NH

· #2 · Jul 12, 2005

Ex
It appears that you need to push the pins thru the trigger, slide assembly and then lift the reciever out, as the grip assembly is one piece.. see the link below
http://www.kel-tec.com/prod01.htm

Save

CLASS3NH

· #5 · Jul 12, 2005

Ex
I would use a pin punch, or a small allen type punch, to tap the pins out and pull them thru the other side with either a small plyer (so you can "feel" the spring tension as it slides through) I believe that once you push the trugger assy and slide assy out, you'll be able to push the slide off, via to the rear and up, as it appears there are machining slots for this operation.

Save

1 - 2 of 8 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month