Defensive Carry banner

1 - 4 of 4 Posts

·
Registered
Joined
·
3,063 Posts
Discussion Starter #1
I need a bit of a favor if anyone has a PF9, a digital camera and a few spare mins. I read a thread on another board stating that a PF9 mag grip extenstion will fit a Taurus pt709 mag but it doesn't look "factory". I am hoping that someone could take a few pictures of their mags base plate and the bottom of the mag and post them. Also, if you take a few measurement it would be much appericated. Most important measurements would be the length, width and height. I am wondering if it would be possible for me to use a dremel tool to just grind the PF9 grip extension down to fit the 709. If the "clippy think" on the base plate attaches to the 709 mag it seems like it wouldn't be to hard to pull off. Any help would be much appericated!

Thanks!
 

·
Registered
Joined
·
189 Posts
The PF-9 extensions are small and were insufficient for me to get my pinky on, so I did Dremel mod's of Pierce grip extensions meant for the Kahr PM9. I am now a happy camper with two spare PF-9 extensions.
PM me with your snailmail address and I'll send you one to try out FOC
 
1 - 4 of 4 Posts
Top