Weird FTE

621 Views 2 Replies 3 Participants Last post by bmcgilvray, May 15, 2013

baruffic

Discussion Starter · May 15, 2013

I borrowed a friends browning hi power and getting a weird failure to extract everyone once in a while. The brass is still in the chamber, completely in the chamber, and it seems to be stuck in place because the tip of the next round is holding it there. I have tried multiple different ammo, including some 124 grain hollow points, but I can't figure out where the problem might be, any thoughts?

Save

1 - 3 of 3 Posts

9mmjoy

· #2 · May 15, 2013

my nano was doing this sometimes and it could be an extrator issue? im not real familiar with that gun but just a guess also make sure its clean and oiled well. just to rule that possibility out.

Save

bmcgilvray

· #3 · May 15, 2013

A weird possibility but could the pistol have a heavier than standard recoil spring installed! Wonder if a standard recoil spring would solve the issue.

Save

1 - 3 of 3 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month